Be sure not to loosen the screw too much so as not to cause the screw to fall from the wheel and become lost. Use your screwdriver to loosen the screw that holds the pin in place. If everything else is in order with your timer to this point, you will want to adjust the timer "On" and "Off" pins to set the time to turn your filtering system on and off. You want to turn the wheel until the timer reflects the correct time with the timer marker at the front of the wheel. You will be able to rotate the wheel when it is about 1/8 inch out. If you want to set the time, you should take two fingers and pull the wheel gently toward you away the timer box. The time bar is located in the center of the timer wheel. Sometimes the cause of a malfunctioning pool timer is the adjustment of the timer wheel. If Step 1 does yield positive results, move on to Step 3. This ensures that the steps to installing the timer are done professionally and won't compromise your safety. It is recommended that you consult a professional electrician to install the timer. If the instructions in Step 1 don't yield positive results, it is necessary to replace your timer. Plug your pump directly into the Programmable Timer and plug the timer into any grounded outlet. Use this weather-resistant outdoor timer for your above ground pool or outdoor lighting. If it is on, your timer will need to be replaced. This 15 Amp pump timer lets you set your pool pump to run for 2,4 or 6 hours from sunrise and 2, 4 or 6 hours from sunset or any combination. If it is on, check the circuit breaker to ensure that it is in the "On" position. I have an Aqua logic control that wont keep time, I have to manually change the day and time everyday, could not find any backup battery and the pool store says I need a new board, Im pretty handy, and fix most things myself and save a ton of money, this one has me baffled, any help would be appreciated. Check the manual override switch beneath the timer dial and ensure that it is on. If the pins have not moved, you are not receiving power to the timer. If the pins are in a different location, power is being supplied to your timer and it is functional. Because of this, you will want to return to the timer in 24 hours to see if the location of the pins are different. Leave the paper inside your timer box so that you do not mistakenly misplace it. Take a good look at the position of the pins and write down the locations.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |